Power Figures

nissanman · Post by **nissanman** » Thu Aug 10, 2006 7:24 pm

CA18ET
Stock T2 Turbo
FMIC
2.5inch Exhaust
GT40T Coils
Timing Advanced
K&N Pod Filter

Graham West Dyno Centre-

113RWKW @ 10psi

FLY PSI · Post by **FLY PSI** » Mon Aug 14, 2006 6:23 pm

SR20DET
GT28RS
pod filter
Tomei cams
fmic
SS exhaust manifold
3in turbo back exhaust

Recorded (Dyno dynamics,G-Force race engines)
269.8rwhp (201rwkw)@1bar. (with cyl1 down on compression)

gadget1382 · Post by **gadget1382** » Wed Aug 16, 2006 12:20 am

CA18det auto
600x300x76 FMIC with really short custom piping
Twin Thermo's
Custom 3" turbo back exhaust with high flow, muffler and resinator

In the coming weeks
Bosh 040
Chip and tune

Hoping i'll get 130rwkw with the tune at 14 - 15 psi

Jono · Post by **Jono** » Wed Aug 16, 2006 1:22 am

CA18det
Supra fmic
X-Force dump pipe
3in exhaust
Performance Chip

130rwkw @7psi (Run conducted by previous owner)

Post by **castle** » Wed Aug 16, 2006 10:08 am

SR20DET
T28 Turbo
FMIC
3 Inch exhaust from turbo back
Pod filter
PLMS Chipped ECU

183.9RWKW @ 1bar.

07/06/06 @ Boostworx

Shinigami · Post by **Shinigami** » Wed Aug 16, 2006 5:01 pm

this may sound stupid but how can you tell how much rwkw is in horsepower??

John

Post by **castle** » Wed Aug 16, 2006 5:04 pm

1 Horsepower = 0.7457 kW

So:

100 Horsepower = 74.57 kW

and,

100 kW = 134.10 Horsepower

gadget1382 · Post by **gadget1382** » Wed Aug 16, 2006 5:24 pm

Jono, i think ur car is set at 14psi normally from what i remember, so you'd have a few extra horses than what u think.

gerryb · Post by **gerryb** » Thu Aug 17, 2006 3:29 pm

Ther's usually a percentage of power lost through the drivetrain does anyone know waht percentage of flywheel hp/kw's roughly = rear wheel hp/kw's ?

FLY PSI · Post by **FLY PSI** » Thu Aug 17, 2006 5:48 pm

gerryb wrote:Ther's usually a percentage of power lost through the drivetrain does anyone know waht percentage of flywheel hp/kw's roughly = rear wheel hp/kw's ?

Ive been told anywhere between 20-30% loss so i normally work it out at 20% as if anything that would be an under estimate.

so i guess 250kw@engine= 200rwkw